veneer slicer, surface planer, super surfacer, knife grinder, veneer dryer

   Veneer drying system





RD-4 / RD-6 / RD-8
Specification Heat source : Gas or Kerosine-oil
Burner : 1 unit (RD-4, 6) , 2 unit (RD-8) of "WEISHAUPT"
Inlet width : 1,000 mm
Heating length : 4,000 mm(RD-4) , 6,000 mm(RD-6), 8,000 mm(RD-8)
Operation height : 725 mm
Feeding speed : 0.8 ~ 3.2 m/min. (inverter control)
Casing : Panel-structure with insulation board
Circulation fan : 3 unit x 2.2 Kw with inverter control
Exhaust fan : 1 unit x 2.2 Kw with inverter control
Feeding motor : 1 unit x 0.75 kw geared motor with inverter control
Rollers : Stainless steel top
Temparature : Max. 150º C with automatic control
Feature -Drying and pressing process can be done with high efficiency
-Stainless rollers protect veneers from contamination



RD-4J / RD-6J / RD-8J
Specification Heat source : Steaml
Steam heater : 2 unit (RD-4J) 100,000 kcal/hour
, 3 unit (RD-6J) 150,000 kcal/hour, 3 unit (RD-8J) 200,000 kcal/hour
Inlet width : 1,000 mm
Heating length : 4,000 mm(RD-4J) , 6,000 mm(RD-6J), 8,000 mm(RD-8J)
Operation height : 725 mm
Feeding speed : 0.8 ~ 3.2 m/min. (inverter control)
Casing : Panel-structure with insulation board
Circulation fan : 3 unit x 2.2 Kw with inverter control
Exhaust fan : 1 unit x 2.2 Kw with inverter control
Feeding motor : 1 unit x 0.75 kw geared motor with inverter control
Rollers : Stainless steel top
Temparature : Max. 150º C with manual adjustment
Feature -Drying and pressing process can be done with high efficiency
-Stainless rollers protect veneers from contamination







Page Topª
Copyright© 2007 Marunaka Tekkosho Inc., All Rights Reserved.